아이티즈

기술지원

시작하기

아이티즈 > 기술지원 > 시작하기

2. Printer 설치 및 준비 조회: 1,481   작성일: 18-03-19  
글제목: 2. Printer 설치 및 준비

Unpacking your V-One

Once you've opened the box, remove the layers of foam one by one. Place them aside for now, and remove the V-One from the box. Avoid picking the V-One up by the bridge. Instead, use two hands and lift it from the base.

 

 

in-the-box-min.png

 

 

The V-One comes with all the tools and accessories you need to get started: 

 

Consumables

Tools & Accessories

1- Conductive Ink Cartridge

1 - Probe

1- Solder Paste Cartridge

2 - Dispensing Units

1- Solder Wire Spool 

3 - Caps

1 - Flux Syringe

1 - USB Cable

1 - Burnishing Pad

1 - Power Cable

1 - Hello World Circuit Kit

4 - Thumbscrews

10 - 2" x 3" Substrates

2 - Board Clamps

6 - 3" x 4" Substrates

4 - Nozzles 

 

Printer Anatomy

Take some time to get comfortable with the parts of the V-One. We will be working

with them over the next couple of sections.

 

Probe:

labeledProbe-min.png

 

Dispenser:

labeledDispenser-min.png

 

V-One:

diagram-v-one-scaled.jpg

Assembly

The V-One comes with 2 identical dispensers for the 2 ink cartridges: conductive

ink and solder paste. Now that you are familiar with the parts, you can start

assembling the V-One dispensers.

Be sure the dispenser's plunger is fully retracted before assembling. If the

plunger is too far out it can push ink out during assembly.

  1. 1. Remove the dispensing cap from the cartridge sheath. Remove the green lids from the conductive ink cartridge.
  2. 2. Insert conductive ink cartridge into the sheath with the ink level visible through the viewing window.
  3. 3. Twist the dispensing unit back into the cartridge sheath.
  4. 4. Carefully twist the nozzle onto the end of the cartridge.

The conductive ink cartridge is used in the video. The same procedure applies for

assembling the solder paste dispenser.

 

Software Installation

Visit our downloads page to download and install the latest V-One Desktop application and drivers. 

 

Setting Up Your V-One

Find a spot for your V-One.

  • A flat, level surface with minimum vibration is optimal.
  • A well ventilated area is recommended.
  • Do not place the V-One on a surface that is susceptible to heat damage.
  • Avoid exposure to extreme temperatures
목 록